How To Repair Your Freezer If Running But not freezing? The reason why your freezer is not cooling is most likely caused by a faulty compressor. Check the start relay for continuity with a multimeter. If the starter relay has a burnt smell, it might be the culprit. Otherwise, your freezer is likely to cool but not freeze. To repair this issue, you will need a multimeter.
How To Clean A Dirty Evaporator Coil Or Condenser
The refrigerator may be operating, but the evaporator coils are dirty. Cleaning them may be an easy fix, but you must keep in mind that they can’t be seen without turning it on. This means that you have to take a step back and turn it on again. To do so, you can get a simple vacuum tool, which can cost just a couple of dollars. To get a better view of the coils, you can also buy a brush that is made for the purpose, which will catch debris. After you’ve cleaned the coils, replace the panel.
If your refrigerator is running but not freezing, the problem could be the evaporator coils or the condenser. You should clean these regularly to prevent the entire system from malfunctioning. You can also do this task yourself if you are comfortable with DIY. However, make sure that you turn the thermostat off before you begin.
How To Test A Fault In The Start Relay
If your refrigerator has stopped cooling, the problem may be the compressor. It may run occasionally or not at all. Either way, the freezer will not freeze and will smell burnt. If this is the case, you can test the start relay for continuity using a multimeter. Make sure that the start relay has continuity before attempting to repair the unit. If you think it’s a fault in the compressor, check the start relay as well.
If the relay is not working, the compressor motor may be failing. If the compressor motor is not functioning properly, you’ll have to replace the motor. However, if the compressor motor is not functioning, a faulty start relay may be the culprit. To test the relay, use a multimeter to check for continuity. If the unit is running but not freezing, you may need to replace the compressor. If this doesn’t fix the problem, call a technician to repair it.
How To Fix Evaporator Fan Motor Is Faulty
If you’re wondering how to fix a faulty evaporator fan motor in your freezer, you’ve come to the right place. You’ve probably heard about this problem before and wondered if you can repair it yourself. The good news is that it’s not as difficult as you might think! To begin, first unplug your freezer and disconnect the wiring from the control board. You’ll need a multimeter to check the resistance of the red and blue wires. To test whether or not the wires are broken, use a multimeter to check the continuity of each.
If you hear high-pitched noises, the evaporator fan motor is probably the culprit. It is located behind the rear panel of your freezer and is often the source of the problem. Before you can perform repairs, you’ll need to check the evaporator fan motor resistance by turning on the freezer and checking for continuity. You can also try unplugging your freezer for 24 hours to clear up any frost over the coils.
Check below for the list of the cities that our technicians service within Fulton County:
Atlanta, Johns Creek, Dunwoody, Milton, Roswell, Brookhaven, Sandy Springs, Alpharetta